aseboero.blogg.se - Prtg snmp trap receiver

#Prtg snmp trap receiver manual#
#Prtg snmp trap receiver code#

You will then see the options described below. To change a setting for this object, disable inheritance by clicking on the check mark symbol in front of the respective setting name. Often, best practice is to change them centrally in the Rootgroup's settings. However, there is an advanced procedure to do so.īy default, all following settings are inherited from objects higher in the hierarchy and should be changed there, if necessary. By default, you cannot exclude single channels from stacking, if they use the selected unit. All channels with this unit will be stacked on top of each other.

This setting is only available if stacked graphs are selected above.

#Prtg snmp trap receiver manual#

Note: This option cannot be used in combination with manual Vertical Axis Scaling (available in the Sensor Channels Settings settings). This will generate an easy-to-read graph which visualizes the different components of your total traffic. Stack channels on top of each other : Stack channels on top of each other to create a multi-channel graph.Show channels independently (default) : Show an own graph for each channel.Note: You can set another primary channel later by clicking on the pin symbol of a channel in the sensor's overview tab.ĭefine how different channels will be shown for this sensor. The available options depend on what channels are available for this sensor. In the device tree, the last value of the primary channel will always be displayed underneath the sensor's name. Select a channel from the list to define it as the primary channel. Please enter a string or leave the field empty. If the message does include this string, the sensor will be set to a Warning status. Define which string must not be part of the trap's message. This setting is only visible if a sensor status change is enabled above. If the message does not include this string, the sensor will be set to a Warning status. Define which string must be part of the trap's message. Depending on Content : Put the sensor to a warning status, depending on the content of the messages received.Never : Never put the sensor to a warning status.Please enter an integer value or leave the field empty.ĭefine when the sensor will be put to a Warning status.

#Prtg snmp trap receiver code#

Make sure the value matches exactly the code in the trap. If you enter something here, only traps with this code will be regarded. Please enter a string or leave the field empty.ĭefine if you want to filter for a specific trap code value only. Make sure the string matches exactly the value of the sender value in the trap. If you enter something here, only traps with this sender will be regarded.

Note: Use with caution this option may create a lot of log entries!ĭefine if you want to filter for a specific sender only.

Write message to log and fire 'change' trigger : Write an entry to the PRTG log file every time a message is received and fire one change trigger after each scanning interval, if messages were received during this interval.

Do nothing : Do not perform any action.

We recommend using the default value.ĭefine what will be done when a message comes in. ĭefine the port on which SNMP traps are received. If you want to disable the validation of your entry entirely, add the string norfccheck: at the beginning of your OID, for example, norfccheck:2.0.0.0.1. However, entering OIDs starting with 1.0, or 1.1, or 1.2 is also allowed. Enter the OID of the SNMP object you want to receive numerical data from.